Assembly Instructions

Remove jacket material to 3/8".

Fold braid back over jacket.

Remove foil and cut dielectric to length of 1/4". Be careful not nick copper jacket of center conductor. Remove dielectric fuzz.

If using separate crimp ring, slide over folded back braid.

If foil is burred, twist so that corner at point A is smooth and provides a lead for the connector mandrel.

Install connector mandrel over foil and underneath the braid; trim braid if desired. Point A should be approximately even with inner surface of connector.

Slide crimp ring into place over braid and adjacent to connector body. Crimp with proper tool.